Nauticus boat leveler trim tab
Trim tabs & accessories. Steering & control
- Color-coded wiring in 25' to 40' lengths with quick connects fittings, meets federal standards for heat, pull and insulation, making installation easy
- They are custom designed for Insta-Trim Boat Leveler Co., epoxy sealed and humidity resistant, thereby preventing shorting out
- The solenoids lock the tabs in any position, eliminating driftback. Barb type hose fittings provide tight, secure connections
- A powerhouse with coated wirings and a thermal overload that resists temperature and amperage build-up
- 1 3/4" stack windings and top mounting eliminated oil leakage
- The motor is mounted with stainless steel nuts and bolts, and is easily disassembled
- Swivel type brackets allow cylinders to be mounted an adjusted to any angle
- Knockout pins act as shear pins it tab strikes an object
- Designed and engineered exclusively by Instatrim
- The built-in bypass is factory set at 400 P.S.I. tolerance held to .00025
- Amperage doesn't exceed 16 because the unit circulates oil, rather than stalling out or trying to pump additional pressure
- 4 1/2" D x 6" W x 11"H, high impact ABS plastic cover with a built-in oil reservoir mounts easily with two screws
- The filler is located in front. Our cover protects the motor from occasional wash down
- Impact resistant, fiberglass reinforced nylon cylinders eliminates expansion and resists ultra-violet rays
- Two expanding type seals, plus O-ring, eliminates high and low pressure leaks
- Barbed cylinder fitting and an inserted tubular rod prevents hose blow-off and breakage
- A stainless steel spring retracts the cylinder when the boat is not in motion
- 12 gauge 304 stainless steel trim tabs are available in standard and custom lengths
- They are guaranteed against electrolysis, remaining strong and secure
- Insta-Trim's hinges prevent most spray and can be used for transom or bottom mounting
- Designed and manufactured exclusively for Insta-Trim with nylon-reinforced webbing and protective PVC coating
- Rated at 2000 lb. burst pressure, 15' of hose is supplied for your system
- Entering the transom 6" above the water line, the hoses are held securely with hose trim
- Stainless steel clamps hold the hose to barb fitting at the solenoid
- Mounted on the dash they are easy to operate
- 2TP Micro switch with silver contact points adjust the tabs for maximum control and performance
- One pint of Insta-Trim biodegradable transmission oil, funnel and mounting hardware is supplied
| деталь | цена | |
|---|---|---|